Painting Alder Guitar Body

November 09, 2021

I’m starting a telecaster project, alder body already purchased. When it comes to painting, different woods need different prep work.

JEM Guitar Body AANJ Super Light Premium Alder Gitar

From their european warehouse in brussels, stagg supplies musicians around the world with more than 5,000 different musical instruments and accessories.

Painting alder guitar body. Id recommend using a wood for the body that doesn't require a grain filler like alder, poplar or pine. However, painting your guitar isn't as easy as just taking a brush with paint to the body of the guitar. I’ve read online that with alder there’s no need to grain fill prior to sealing/priming/painting due to the tight nature of alder’s grain.

In the majority of cases, i have found at least 3 coats will ensure a nice finish. Then when dry lay the guitar flat. That will take away some complication.

Looking at the body i have it does look pretty tight, but i’m not sure if some gaps may become apparent when the paint is applied. I want to stain this body, do i need to seal it first, or can i apply the stain to the bare wood then use sealer before the clear, or is alder ok to clear over the stain without any sealer, i've been painting cars and finishing furniture for years, but a guitar seems to be a little different. Transparent, burst, and dye finishes will also vary based on the color of the wood they are sprayed over.

Do the alder body, some autozone primer ($5), 1 can of reranch surf green ($15), (2) cans of reranch clear ($15 ea.) and a starter pack of micromesh from lmi ($20), some rubbing compound and polish, and a lot of elbow work and 45 days, you can have a beautiful finish for less than $100. Mahogany, for instance, has a very open grain and needs more grain filling than alder prior to painting. You can use a fine grain of sandpaper of to smooth out the wood on the guitar.

Use a block of wood in the pickup and/or control cavities to suspend the body an inch or so above the work area. Your decision should depend on how prominent the grain is in the alder (some alder bodies have reasonable grain patterns showing), and what you find aesthetically agreeable. You’re going to want to work over the entire body of the guitar with a medium grit sandpaper (120 grit) and go back over again with the entire body and use an even finer grit of paper (220 grit).

Once done, leave the guitar body and neck to dry as per the manufacturer’s recommendation on the finishing product. Please read our article on sanding a guitar body prior to painting. As with any wood however, preparation is absolutely fundamental to achieving a good result.

When spraying hang the guitar from a hook. From there, you can apply a coat of sealer, base color, and finally a clear gloss coat that will make the finish shiny. Painting alder is an easier process.

Chinese maple, canadian maple, flame maple, bass wood, mahogany: The reduction in finishing costs is why fender used alder bodies for their solid colours and sunbursts from the late fifties. Finishing alder is much easier than painting an ash body as the wood is more tightly grained.

You’ll also want to mask off the neck pocket, pickup routes, etc to make sure that paint does not get into any of these areas. I need to know, whats the best way to paint the guitar body. Probably more than you will be able to level after clear coat.

Computer monitors vary, and the colors shown above are an approximation. Sanding a guitar body prior to painting in the following article, we're going to cover some of the basics of guitar sanding. Alder black korina mahogany maple swamp ash.

While it may seem fairly obvious, in essence, correct preparation will make or break the quality of your guitar kit's finish so it makes sense to take the time to do the job properly. The hand paint will be raised. I think spray cans aint soo good, so whats about car paint?

When you hand paint a design on the guitar. Before you start painting your guitar, you'll need to take it apart and remove the old paint. Preparation and patience are the other ingredients.

Browse through the dropdown categories for ideas to customize your guitar body order. Heavywight alder guitar pictures photo of this guitar when producing in our factory unfinished alder bodies waiting for painting assembled before package more choices wood: Im thinking of painting guitar in car paintshop, i mean, if i can do.

Our catalogue includes the best beginner electric guitars and classical guitars, violins, electric violins and other string instruments, a wide range of cymbals, as well as a fine selection of brass instruments and woodwind instruments. As a practical matter you will find it easiest to hang the guitar and spray the top back, and sides in sections.

Telecaster heavy relic Body Artys Custom Guitars Shop Tele